Skip to content
WRT India Contact WRT

WDM100 Instant Grease/Oil Ferrous Debris Tester

LabOnsite

Measure ferrous wear debris in grease and oil samples in two seconds. A compact touchscreen tester helps maintenance teams check wear close to the equipment.

WDM100 Instant Grease/Oil Ferrous Debris Tester

Measure ferrous wear debris in grease and oil samples in two seconds. A compact touchscreen tester helps maintenance teams check wear close to the equipment.

Bring a wear check closer to the maintenance decision

When a maintenance team sees a change in machine behaviour, a quick check of ferrous debris can help decide what needs further investigation. WDM100 gives oil and grease samples a dedicated wear-measurement route, with a two-second measurement and a small sample requirement. It fits teams that need an accessible screening tool alongside their wider inspection and lubricant-analysis programme.

Where WDM100 fits in a maintenance programme

Grease checks during a planned maintenance stop

A team maintaining grease-lubricated equipment may have a sample available while the asset is already accessible. WDM100 accepts a 2 mg grease sample, allowing a ferrous-debris check to be included in that maintenance visit. Record the asset, sampling point and operating context with the result so a change can be investigated against earlier findings.

Oil-sample screening across a group of machines

For an industrial maintenance team checking several lubricated assets, a dedicated debris measurement can help organise follow-up work. WDM100 uses a 2 ml oil sample and a touchscreen interface. Use the measurement with inspection history and other oil tests to identify which samples merit closer attention; it does not identify a particular failed component on its own.

What to review before selecting WDM100

Consider WDM100 when ferrous material in oil or grease is the measurement you need. Compare it with WDPQ200 if your programme specifies PQ-index reporting, and with WAS300 if the task also requires several oil-condition and contamination parameters. These are different measurement workflows, rather than interchangeable model names.

Common application questions

Can WDM100 test both grease and oil?

Yes. The stated sample sizes are 2 mg for grease and 2 ml for oil. Confirm the sampling workflow and required measuring range for your programme.

Does a ferrous-debris result replace a complete oil analysis?

No. It addresses ferrous wear debris. Viscosity, moisture and particle-cleanliness questions need the relevant additional measurements.

Key features

  • Two-second sample measurement
  • 5.5-inch touchscreen
  • More than five hours of battery operation
  • Oil and grease sample testing

Technical specifications

Parameter Specification
Test time 2 seconds
Sample size 2 mg grease / 2 ml oil
Sensitivity 1 mg/l (ppm)
Repeatability <1% RSD
Test range 0–5,500 mg/l (ppm); higher configurations on request
Standard ASTM D8120
Dimensions / weight 250 × 218 × 133 mm / 2.7 kg
Power AC 100–240 V, 50/60 Hz

Tell us what you need to monitor.

Talk to WRT India